Indoor & Micro Electric Planes Talk about indoor & Micro electric powered flight here

Question regarding Spektrum AR6400 micro receiver

Old 12-12-2010, 08:11 PM
Thread Starter
Join Date: Mar 2006
Posts: 24
Default Question regarding Spektrum AR6400 micro receiver

How do you assign the function of the rudder servo that is a fixed part of the PC board, to the aileron channel on the transmitter when you intend to use this receiver in a 3 channel airplane without ailerons?
(Using a conventional receiver, where all of the servos just plug in; itís just a matter of plugging the rudder servo into the aileron position on the receiver.)
I suspect that this is a simple task; but this is my first Spektrum transmitter, and Iím not familiar yet with programming it, so Iíd sure appreciate a ďbeginner 101Ē explanation concerning how to do it.
Bob W
BOBWRC is offline  
Old 12-12-2010, 08:32 PM
Heli Jim
Grandpa, Golfer, Pilot
Heli Jim's Avatar
Join Date: May 2007
Location: Wisconsin
Posts: 1,404

Go into the mixing section and Mix the Aileron and Rudder 100%
Heli Jim is offline  
Old 12-13-2010, 05:02 AM
Thread Starter
Join Date: Mar 2006
Posts: 24

Thanks very much for your reply to my inquiry, and for your input
I did as you suggested, but it took me a while to figure out how eliminate the rudder stick movement from also controlling the rudder. Finally figured out how to set the proportional mix ratio for the rudder stick to zero.
"All's well that ends well" so your input did put me on the right track, and was much appreciated!
Thanks again,
BOBWRC is offline  

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright © 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.10621 seconds with 12 queries