For Sale Visionaire electronics (motor, ESC, servos, receiver, misc)
03-07-2017, 09:04 PM
#1
Member
Thread Starter
Join Date: Mar 2008
Posts: 303
Visionaire electronics (motor, ESC, servos, receiver, misc)
Hi,
I'm looking to sell the electronics out of my Visionaire which I crashed last summer. The plane itself only had about 15 flights on it. The crash itself wasn't that bad I just crunched one of the wings and the front nose section where the battery goes collapsed. I'm not a builder so a new buy was my direction. You can actually watch the video here to see that it wasn't very much of an impact and it was into high grass. I can actually see the video of the crash here if you want:
https://youtu.be/DPdkXwsSvOo
I just tested all the electronics. Everything binds easily in properly so the receiver is unaffected. I tested the motor and the prop itself and it was still spinning perfectly straight so nothing is affected on the motor. And obviously the ESC is fine as well. The two servos stuck together that controlled the rudder are perfectly fine, there's no damage to them. The other singular servo sounds like it has a stripped gear as it only turns one way. I assume you can probably just buy replacement gears for it. The 4th servo in the other wing that was undamaged and works perfectly fine. It's still in the wing.
These are the links to the components new:
Motor - $50
http://www.e-fliterc.com/Products/De...rodID=EFLM7225
ESC – $70
http://www.e-fliterc.com/Products/De...dID=EFLA1040LB
Motor shaft – $6
http://www.e-fliterc.com/Products/De...odID=EFLM72251
Prop adaptor – $6
http://www.e-fliterc.com/Products/De...odID=EFLM72252
Motor mount – $6
http://www.e-fliterc.com/Products/De...ProdID=PKZ6528
Servos – $17 per servo
http://www.e-fliterc.com/Products/De...rodID=EFLR7155
Receiver – $90
http://www.e-fliterc.com/Products/De...rodID=SPMAR635
FYI: The one servo in the wing I was just planning to cut it out of the wing after I found a buyer. I just left it in the wing as a spare swap wing.
The housing extension has been removed from the motor too
All of the above are approximately $300 new. As I said one servo has a stripped gear as so I'll give that for free. So let's say $280.
I was looking for $200 for everything. O.B.O. I'll listen to reasonable offers for all or parts. The buyer to pay shipping. You can tell me your preferred shipping method and destination and we can figure out that price. P7C5L5 is my postal in Ontario.
Send me a private message on this board. Or an email to rjcella@tbaytel.net. Thank you
Rob
I'm looking to sell the electronics out of my Visionaire which I crashed last summer. The plane itself only had about 15 flights on it. The crash itself wasn't that bad I just crunched one of the wings and the front nose section where the battery goes collapsed. I'm not a builder so a new buy was my direction. You can actually watch the video here to see that it wasn't very much of an impact and it was into high grass. I can actually see the video of the crash here if you want:
https://youtu.be/DPdkXwsSvOo
I just tested all the electronics. Everything binds easily in properly so the receiver is unaffected. I tested the motor and the prop itself and it was still spinning perfectly straight so nothing is affected on the motor. And obviously the ESC is fine as well. The two servos stuck together that controlled the rudder are perfectly fine, there's no damage to them. The other singular servo sounds like it has a stripped gear as it only turns one way. I assume you can probably just buy replacement gears for it. The 4th servo in the other wing that was undamaged and works perfectly fine. It's still in the wing.
These are the links to the components new:
Motor - $50
http://www.e-fliterc.com/Products/De...rodID=EFLM7225
ESC – $70
http://www.e-fliterc.com/Products/De...dID=EFLA1040LB
Motor shaft – $6
http://www.e-fliterc.com/Products/De...odID=EFLM72251
Prop adaptor – $6
http://www.e-fliterc.com/Products/De...odID=EFLM72252
Motor mount – $6
http://www.e-fliterc.com/Products/De...ProdID=PKZ6528
Servos – $17 per servo
http://www.e-fliterc.com/Products/De...rodID=EFLR7155
Receiver – $90
http://www.e-fliterc.com/Products/De...rodID=SPMAR635
FYI: The one servo in the wing I was just planning to cut it out of the wing after I found a buyer. I just left it in the wing as a spare swap wing.
The housing extension has been removed from the motor too
All of the above are approximately $300 new. As I said one servo has a stripped gear as so I'll give that for free. So let's say $280.
I was looking for $200 for everything. O.B.O. I'll listen to reasonable offers for all or parts. The buyer to pay shipping. You can tell me your preferred shipping method and destination and we can figure out that price. P7C5L5 is my postal in Ontario.
Send me a private message on this board. Or an email to rjcella@tbaytel.net. Thank you
Rob
