Power Systems Talk about motors, ESC speed controllers, gear drives, propellers, power system simulators and all power system related topics

T-28 ParkZone ESC/Motor

Old 08-31-2013, 04:32 PM
Thread Starter
Join Date: Jul 2009
Location: Valrico, FL
Posts: 30
Default T-28 ParkZone ESC/Motor

I crashed my T-28 plane. I was flying straight and level when the plane started to act as if I was moving the rudder, elevator and aerliron in both directions rapidly and all at the same time. I could not control it and it crashed into the ground. Is it possible that the esc or motor could have overheated. I normally fly two aircraft alternating between them. This time, I didn't, I was on my second flight. The plane was out far enough that I could not hear the motor. I live in Florida and so there is plenty of heat. Also, with the cowling around the motor and esc I don't think much air flow gets in. Any comments would be welcome. This has happened to me before and I replaced the esc because it crashed into a small pond.



Last edited by Fritzngertie; 08-31-2013 at 06:37 PM.
Fritzngertie is offline  

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell or Share My Personal Information -

Copyright © 2023 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.07246 seconds with 13 queries