Default Turnigy G10 - 1200kv or 1100kv for PZ T-28? - WattFlyer RC Electric Flight Forums - Discuss radio control eflight

General Electric Discussions Talk about topics related to e-powered RC flying

Default Turnigy G10 - 1200kv or 1100kv for PZ T-28?

Old 11-28-2014, 03:54 AM
  #1  
amorak
New Member
Thread Starter
 
Join Date: Jun 2010
Posts: 6
Default Default Turnigy G10 - 1200kv or 1100kv for PZ T-28?

Hi all,

For a Parkzone T-28 fomay, running 3S cells on a Sky Power 45A (60 burst) ESC (may run 4S cell as well?) would you get a G10 1100kv or 1200kv? Is the run time going to be significantly impacted between the two?
amorak is offline  
Old 11-28-2014, 07:21 AM
  #2  
thepiper92
Warbird Fanatic
 
thepiper92's Avatar
 
Join Date: Nov 2013
Location: Winnipeg, Canada
Posts: 1,513
Default

The 1200kV has higher max amps, and slightly higher wattage. The 1100kV is only rated to 3s, not sure why a lower kV motor of the same size would handle less voltage, or much difference in current. The 1200kV will have higher rpm...and since it can pull more current, you should be able to turn a prop the same size as the 1100kv, unless you are going to the max size and pitch, of which the 1100kV can run a bigger prop at the same voltage. I would go with the 1200kV myself, as with more potential draw, and slightly higher watts, it would be a more powerful motor.

From your other post,run time depends on the setup. The 1100kv is max 32amps. If a setup on the 1200kv is pulling 32, then run time would, more or less, be the same. Of course, if you push the 1200kV into 50 amps, run time goes down.

http://www.hobbyking.com/hobbyking/s...ner_Motor.html

Could look at that one too.

With any of these motors you'll get a lot of power, 63 oz of thrust from a 30 oz plane.

Last edited by thepiper92; 11-28-2014 at 07:39 AM.
thepiper92 is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
CHELLIE
Hi-Performance and Sailplanes
2015
05-28-2020 09:50 PM
amorak
Foamies
0
11-28-2014 03:35 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Quick Reply: Default Turnigy G10 - 1200kv or 1100kv for PZ T-28?


Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.10244 seconds with 15 queries