Old 11-11-2009, 02:43 AM
  #2  
flydiver
Super Contributor
 
flydiver's Avatar
 
Join Date: Jan 2007
Location: Seattle, WA
Posts: 2,668
Default

If the lights were on a totally different system and it did that then the RX/ESC probably went bonkers. Had nothing to do with the lipo if you pulled the jumper. All the jumper does is change the low voltage cut-off to be appropriate for lipo.

Unfortunately these are not high quality electronics. I've noticed a pretty high failure rate on the RX/ESC in the last few months. I think a poor batch got out. I'd call HobbyZone and discuss it with them. They are often quite good about it if you are poised and reasonable.
flydiver is offline  
 
Page generated in 0.05668 seconds with 8 queries