WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - bent case park 300 motor
View Single Post
Old 03-24-2012, 12:57 AM
  #6  
Mastyrlock
New Member
 
Join Date: Mar 2012
Posts: 6
Default bent case park 300 motor

Sounds like your right about supporting the inside of the bell next time. Sometimes you learn the hard way. I guess I'm just going to have to get a block of wood and a mallet and go to work on it. Luckily the bell housing the magnets doesn't seem to be bent just the conical front portion if the motor. Has anyone had this happen to them on a small park motor before and happen to have any advice from experience?
Mastyrlock is offline  
 
Page generated in 0.04956 seconds with 8 queries