WattFlyer RC Electric Flight Forums - Discuss radio control eflight - View Single Post - Is there any interest is 3d printed parts?
Old 11-09-2017, 09:22 PM
  #8  
hayofstacks
Super Contributor
 
hayofstacks's Avatar
 
Join Date: Jan 2012
Location: Utah
Posts: 1,780
Default

One example, I am work I on designing a trike gear mount for a 10mm stick. I am trying to come up with materials to use that are readily available, scaleable (even 450 sized motors commonly use a 10" prop. That would be the size of a .40 nitro job) and making it cheap light and strong is a bigger limitation then just making a bracket that will work.

However, it would make a trike gear stupid easy for guys that use 10mm sticks in custom foam board or even balsa built models.
hayofstacks is offline  
 
Page generated in 0.02821 seconds with 8 queries