Search: Posts Made By: Heli Jim
Showing results 1 to 3 of 3
Search took 0.00 seconds.
06-28-2008, 01:47 PM
Replies: 13
Views: 5,490
Posted By Heli Jim

Yes, the two holes are there to get the...

Yes, the two holes are there to get the allignment of the lower rotor head correct.
Two of the screws go thru the head and into these holes.
06-27-2008, 02:56 PM
Replies: 13
Views: 5,490
Posted By Heli Jim

you would want to lube the bearings for the two...

you would want to lube the bearings for the two shafts. There are four in all.
You can put a little on the large gears but it just gets thrown off and then attracts
dirt so I would just stick with...
06-26-2008, 11:06 PM
Replies: 13
Views: 5,490
Posted By Heli Jim

make sure that the bearing that is inside the...

make sure that the bearing that is inside the inner shaft near the bottom is seated into the gear completely. IF not this could cause your problems.
Showing results 1 to 3 of 3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information -

Copyright 2021 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.

Page generated in 0.05044 seconds with 7 queries